Deamon Hunter - Starting Second Artifact weapon quest line Selection problem

[gazzooks]

I think I have checked everywhere in the guide on how to start or select the second artifact weapon questline. I can find it.

Anyone can point me in the right direction?

[ZG Support 1]

If you are 102 load up the Demon Hunter Intro & Artifacts guide.

[glenngull]

Not much help

If you are 102 load up the Demon Hunter Intro & Artifacts guide.

The demon hunter intro is rather long. Could you include the step number so we can just skip to it? Alternatively, could you spin out the artifact weapon quests to make it easier?
I recently went through this with my druid, getting all of the weapons. Getting to the point in the guide where it appears was a chore.

[ZG Support 1]

The guide should skip all of the completed quests and stop on a step asking if you want to go after the artifacts or continue leveling. You click on the artifacts line and it will take you to the steps needed to go after the 2nd artifact. It's not difficult at all and should be all automated for you so you don't have to skip steps.

[aristoblis]

If you are 102 load up the Demon Hunter Intro & Artifacts guide.

I have the same issue. I loaded the Demon Hunter Intro & Artifact Guide and it did automatically advance...all the way PAST the end of the guide and into the next guide.

When I started Legion on my Horde DH, I followed the same steps I did on my Alliance DH...get Veng artifact first, then start leveling in Stormheim, then High Mtn, and so on until I hit 110, then go back and get my Havoc artifact. When I did this on my alliance toon it worked flawlessly.

When I loaded the Intro & Artifact guide for my night elf DH it took me to the Havoc artifact guide. On my blood elf DH, however, when I load the Into & Artifact guide, rather than loading up the Havoc guide, or even giving me an option to pursue a second artifact, it automatically advanced all the way through the Intro guide, then automatically loaded the Stormheim guide and kept on going. I even forced it to reload the Intro guide and then advanced it manually step by step but never saw an option to accept the next artifact.

Finally, I went and accepted the quest from the quest giver on my own, then set my guide viewer to show all steps (rather than the default 1 step at a time) and literally stepped through each one, one by one, until I found the quest I was on (which, by the way, was grayed out in the viewer). Once I manually found and selected the quest step (#120 for those who might be interested) it went on normally from there and worked fine thereafter.

[phenom419]

I have the exact same problem...just goes straight to Stormheim????