Un'Goro Crater - Bad Waypoints

[deleon]

Was doing horde version of Un'Goro crater leveling guide. From step 48 (abandoned research camp) through about step 75 the waypoints are bad. That section needs to be gone through. Step 48 should be way 38, 66 not the top of a mountain. Step 50 should be way 54, 63. Step 51 should be way 55, 62. Step 52 should be way 44, 40. The next ten steps didn't get any better. Ended up using the map with the question marks to figure out where I was supposed to be going.

[ZG Support 1]

I just loaded up the Un'Goro guide on a Horde toon and the coordinates in the steps are accurate according to what you say they should be. When was the last time you updated your guides?

[deleon]

I tell it to check that I'm running current guide versions before I log on to the game each day.

[ZG Support 1]

When you're in game click on the orange down arrow on the guide viewer and on the guide selection window that opens check the version number in the lower left. Make sure that matches the latest version number shown in the desktop client.

The other possibility is that you were experiencing an odd addon conflict that was throwing off the waypoint dots on the map. That can be tested by disabling all other addons and see if the arrow then takes you to the correct location.

[deleon]

Showed the same -- 5.0.13461 as the updater. Might be a conflict but I've moved on at this point and am now in Hellfire. If I run into any similar issues with the guides I'm running now, I'll start turning other addon's off.

[orion148]

I'm having this same problem but most of them are showing that I need to go south when my quests are north. Screenshot

I also disabled all of my addons.

[ZG Support 1]

When you hover the mouse over the red lines what does it say is the coordinates for where it's trying to send you?

[orion148]

Hovering over those shows the correct coordinates, it's the arrow and trail that are incorrect. Super Sticky Tars shows 47:21 but the location that the arrow sends you to is 45:81 ish. and I've tried to make it change the way point by clicking it and right clicking it and selecting it, it just keeps pointing to the area in the screenshot. So it knows the right area, it's just not pointing to it.

[ZG Support 1]

I'll try to see if I can get it to do the same thing to me but it was working fine last time I tried.